3.1.4. Removal and installation of a pedal of coupling

Fig. 3.11. Removal шплинта

Remove шплинт and a washer (fig. 3.11).

Fig. 3.12. Bolts of fastening of a pedal

Unscrew bolts of fastening of a pedal (fig. 3.12).

Check an axis and the pedal plug on wear existence.

Check a coupling pedal on bend and distortion existence.

Check a returnable spring on damage or easing existence.

Check a pedal platform on damage or wear existence.

Fig. 3.13. Pedal height over a floor

Check pedal height over a floor (from an external surface of a platform of a pedal to a floor) (fig. 3.13).

Nominal size "And": 182,7 mm.

Fig. 3.14. Adjustment scheme педели couplings

If the pedal height over a floor does not correspond to norm, adjust it, as is shown in drawing 3.14.

Bolt adjust pedal height then tighten a lock-nut.

ATTENTION After adjustment tighten a bolt so that it concerned a pedal emphasis then tighten a lock-nut.

Rotation of a pusher adjust its length on new height of a pedal then fix a pusher a nut.

ATTENTION At adjustment of height of a pedal watch that the pusher was not displaced towards the main cylinder.

Upon termination of adjustment be convinced that the free wheeling of a pedal of coupling (measured from a surface of a platform of a pedal) is in norm limits.

Nominal rate "In": 6–13 mm.

Fig. 3.15. Free wheeling of a pedal of coupling

If the free wheeling of a pedal of coupling does not correspond to norm, the possible reasons are availability of air in a hydraulic actuator or malfunction of the main cylinder. Pump over a hydraulic actuator and check the main cylinder or coupling (fig. 3.15).